Lynx Audio Interface setup for Cakewalk software

Click Options | Audio | Advanced.  Set your Driver Mode to ASIO.  If you do not see Driver Mode, make sure the box next to “Always use mme interface” is NOT checked.  Click OK and restart the program. 

Next, Click Options | Audio:

On the Drivers tab:

Make sure your Lynx card is selected under both inputs and outputs.  If it appears grayed out, deselect all drivers, in both inputs and outputs, then select your Lynx card.  If changes are made, click OK and restart the program. 

NOTE: Lynx also provides very reliable WDM drivers. If you experience problems in ASIO Driver Mode, you may want to consider using WDM as an alternative.

On the general tab:

Make sure one of your Lynx card drivers is selected as Playback Timing master.  Click OK.  Restart the program if prompted. 

Finally, all audio playback will occur from the Lynx device itself.  Make sure you have your speakers or headphones connected to its outputs.