Tascam Audio Interface setup for Cakewalk software

Click Options | Audio | Advanced.  Set your Driver Mode to WDM/KS.  If you do not see Driver Mode, make sure the box next to “Always use mme interface” is NOT checked.  Click OK and restart the program.  If prompted, allow Wave Profiler to test your hardware. 

Next, Click Options | Audio:

On the Drivers tab:

Make sure your Tascam card is selected under both inputs and outputs.  Deselect any other drivers that may be in the list.  If you make any changes, click OK and restart the program. 

On the general tab:

Make sure one of your Tascam card drivers is selected as Playback Timing master.  Click OK.  Restart the program if prompted.